I just finished assembling a Jet JPS-10 Pro shop 30” Table Saw with cast iron wings and riving knife for the showroom. As someone who has assembled his fair share of tools, this one was quite special. All the pieces arrived in perfect condition. The fit and finish was truly beautiful. The parts went together like they were supposed to and they were all there.
I put it on a Jet Universal Mobile base and even it was easy to assemble. The cast iron wings are quite heavy and for an old man, I needed help so I grabbed a Fastcap Upper hand along with a 4x6 to hold the wing up while I put the screws in. The only other concern was the saw comes upside down so you can install the legs. Once again an old man all along tuning it right side up is no easy task. Fortunately my high stacker allowed me to raise the saw up, and then tilt it up on all fours. I strongly suggest you get someone to help you stand it up!
The fence was easy to install and required no adjustments right out of the box, though I did go through aliment. The blade guard and riving knife were pre-assembled and easy to install, easy to remove, or change as needed. The instructions were clear and easy to follow.
This is one of the best tools I have ever assembled.
- Riving knife maintains close blade proximity to reduce chance of kickback
- Integrated arbor lock is accessed from table top for rapid blade change
- Blade guard and riving knife have quick release for tool-less mounting and removal
- Enclosed cabinet with exclusive leg stand design for easy assembly
- Heavy duty cast iron table with T-style miter gauge slot
- Sloped cabinet floor and 4” extraction port enhance dust collection efficiency
- Easy-to-reach control switch
- Rigid, left-tilting cast iron trunnion
- Powder coated paint for a long-lasting, chip-resistant finish
- 10” blade included
Specifications:
- Style (Type) Contractor
- Blade Diameter (In.) 10
- Arbor Diameter (In.) 5/8
- Arbor Speed (RPM) 4000
- Maximum Depth of Cut (In.) 3-1/8
- Maximum Depth of Cut at 45 Degrees (In.) 2-1/8
- Maximum Rip Left of Blade (In.) 12
- Maximum Rip Right of Blade (In.) 30
- Table in Front of Saw Blade at
- Maximum Depth of Cut (In.) 10
- Maximum Diameter of Dado (In.) 8
- Maximum Width of Dado (In.) 13/16
- Table Type Cast Iron
- Table Size with Extension (L x W) (In.) 27 x 44
- Miter Gauge Type T-Slot with Stops
- Dust Collection Minimum CFM Required (CFM) 350
- Dust Port Outside Diameter (In.) 4
- Motor Power (HP) 1-3/4
- Motor Phase (PH) 1
- Motor Voltage (V.) 115/230
- Prewired Voltage (V.) 115
- Motor Amps 15/7
CA Prop 65 WARNING: Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance know to the State of California to cause cancer. Avoid inhaling wood dust or use dust mask or other safeguards for personal protection.