Delta 22-591 Delta Replacement Blades for 22-590
SKU: 22-591
Delta 22-591 Delta Replacement Blades for 22-590
How to Change the blades
Raise the cutterhead above 4” depth of cut.
Remove the screws holding the chip deflector or dust port in place, then remove the deflector/port.
Insert the supplied wrench, and turn the cutterhead until it locks in place.
Remove seven screws and use magnetic end of wrench to remove the hold down bar.
Place the magnetized end of the wrench at the center of the knife, left the wrench until the knife separates from the pins.
Repeat on remaining (2) two knives.
Knives are double sided. If the 2nd side is unused rotate the blades 180 degrees. If both sides are used replace with new blades.
Place the knives on the indexing pins, and replace the hold down bar tightening all seven screws.
Repeat on remaining 2 (two) knives.