SHERLINE Adjustable Right Angle
Tailstock for 4" Rotary Table

P/N 3702

Purpose and Use

Because of tolerance build-up, it would be just about impossible to offer a tailstock that was perfectly on center with the Rotary Table/Right Angle Attachment combination. The solution offered here is a modification of our standard tailstock which allows it to be adjusted to exactly line up with the center of the Rotary Table in order to allow for perfect alignment between the rotary table and the tailstock while holding long parts between centers.

The base is attached to the mill table with cap screws and T-Nuts. The two socket head cap screws go through elongated slots in the side of the right angle piece and allow for minor adjustments in height when making your set-up.

FIGURE 1—A sample setup for cutting a large gear
showing the Adjustable Right Angle Tailstock in place.

Return to Mill Accessories Section

Copyright 1996, Sherline Products Inc. All rights reserved.
No part of this web site, including the text, photos or illustrations, may be reproduced or transmitted in any other form or by any means (electronic, photocopying, recording or otherwise) for commercial use without the prior written permission of Sherline Products Inc.